Authorized Service & Support | Appliance Repair Done Right

Outdoor AC unit electrical disconnect box opened during contactor replacement and power diagnostics

Restored AC condenser startup after contactor failure

System would not start during cooling demand. Installed a new contactor, tested voltage response, and restored normal outdoor unit operation.

Thermador gas range with oven door open during convection fan repair and performance testing

Balanced oven airflow on a Thermador range

Customer reported uneven baking results. Serviced the convection fan assembly and verified proper heat circulation inside the oven.

Wolf outdoor built-in grill during gas valve repair with lower access panel opened for service

Stabilized burner controls on a Wolf outdoor grill

Customer reported burners would not stay lit. Opened the lower service compartment, repaired the gas control system, and restored reliable burner operation.

Built-in coffee machine opened from rear panel during power board diagnostics and electronic repair

Revived electronics in a built-in coffee machine

Unit would not start or respond to controls. Diagnosed the failed electronics, repaired the power board circuit, and restored normal operation.

Commercial kitchen exhaust hood during ventilation fan repair and airflow service

Improved extraction on a commercial kitchen hood

Kitchen reported weak ventilation and heat buildup. Serviced the exhaust fan assembly and restored proper airflow through the hood system.

Commercial stacked dryer after drive system repair and operational testing

Recovered drum rotation on a commercial dryer

Unit was tumbling intermittently and stopping mid-cycle. Restored the drive system and verified normal drying operation.

Wolf built-in oven during temperature check and preheat test

Checked heating performance on a Wolf oven

Tested preheat cycle, confirmed proper temperature rise, and verified normal bake operation.

Sub-Zero built-in refrigerator opened at top service panel during sealed system repair and cooling diagnostics

Performed sealed system repair on a Sub-Zero refrigerator

Customer reported warming temperatures and extended run times. Accessed the top machinery compartment, repaired the sealed cooling system, and restored stable temperature performance.

Viking built-in oven with lower storage drawer adjusted and realigned during repair service

Corrected lower drawer alignment on a Viking oven

Customer reported the bottom drawer was loose and not closing properly. Realigned the track assembly and restored smooth closing.

Wolf professional range during ignition switch service with control knobs removed and tools on cooktop

Serviced ignition switches on a Wolf range

Burners were clicking continuously after use. Removed the control knobs, serviced the switch assembly, and restored normal ignition operation.

Viking built-in refrigerator with lower freezer drawer opened during ice buildup and defrost system repair

Cleared heavy ice buildup in a Viking freezer drawer

Customer could not close the lower drawer properly. Removed excess ice, serviced the defrost system, and restored smooth drawer operation.

ICE-O-Matic commercial ice machine opened during compressor replacement and sealed system repair

Installed new compressor on an ICE-O-Matic ice machine

Unit stopped freezing and ice production dropped completely. Installed a new compressor, serviced the sealed system, and restored full ice output.

Thermador built-in refrigerator opened at top service compartment during inverter board and cooling system repair

Restored compressor startup on a Thermador refrigerator

Customer reported warm temperatures and no compressor start. Accessed the upper machinery section, replaced the inverter control, and restored normal cooling operation.